Black widow 3D web contrast cut Can Am Spyder Resevoir clutch cap This cover will make a high impact when looking at your spyder and quality at a very reasonable price. The silver and black Resevoir clutch cap have a raised 3D black web design wil attract the eye.
Fits:2008 and Newer Can Am Spyder sm5 se5

product info: this part is made of t6 billet aluminum made from manufature specs it is BLACK ANODIZED NOT POWDER COATED we check all parts for any damage this way we make sure you get high quality no defects or any thing. all parts are original design none have been copied or knocked off they are all original rmw custom parts.
install : takes aprox 5 min remove theorem cap be carful there is brake fluid inside push the clear site glass out the top by pushing the rubber seal up then it comes out of the rubber . then pull the rubber off from the back side / then place the oem rubber gasket on the new reinstall the site glass from the back side there is a small cut in the topp of the gasket that seals around the top of the site glass make sure it is installed back on correct then install cap back on bike and put in new screws included with cap just snug them down so the gasket is not smashed out the screw will not bottom out and the factory ones did not bottom out either so do not over tighten check for leaks and you are ready to go .
warranty 6 MONTH . unless it is cause by install . or road damage of any kind

Your Name:
*Email Address:
Review:
Your Rating:	1 out of 5 2 out of 5 3 out of 5 4 out of 5 5 out of 5
Verification:	(Reload Image)
	*Your email address will not be shared with anyone.